How to properly install a pool fence?

One of the most effective ways to protect children in the pool is to install pool fences. At times, installing pool fencing yourself can be stressful. Pool owners should consider many things. If you do it wrong, your child could be at risk.

As a guide, here's a blog post on what you need to know to properly install pool fencing.

This is an important thing to do before installing pool fencing, read on.

The first thing you should do is check where the fence is going to be installed. You should ensure in advance that this location does not have any underground cables for water, electricity, and gas. This is to avoid problems with underground pipes and cables when installing new fencing.

Tools used for installation should include a drill, post digger, screwdriver, pencil/chalk, gloves, rope, tape measure, spirit level, and concrete mix.

After the above things are set, you can start the installation. Note that the steps below may vary depending on the type of pool fence you are installing.

There are many ways to install pool fencing. Here are some simple installation steps for your pool barrier.

1. Make sure to check the pool fence specifications. This includes pool fence positioning, fence height, pool gates, clearance, NCZ, etc.

2. Clear the area you are fencing. You will also need to measure the area to know the correct amount of material needed.

3. Determine where each post goes and mark it with chalk. You can also run string lines for visual effects on the periphery.

4. Dig all holes approximately 600mm deep.

1. Place the post in the hole and fill it with concrete mix.

2. After securing the posts, install the brackets on the ends of the fence rails. Then screw it to the post.

3. Be sure to check that the clearance meets the specified pool fencing requirements. You can place the fence on a wooden block to ensure the gap is secure.

4. Do this for each side of the column.

1. Fasten the gate's hinge to the fence post. Make sure the gate is open outwards or away from the pool.

2. You can also stand the gate on a wooden block to make sure the height and clearance are correct.

3. After that, fasten the door to the fence post and install the door lock.

4. Check that the door is properly closed and locked in place.

1. Clean the area and remove all wood blocks from the fence.

2. Let the cement dry. After this, backfill the posts with some soil to cover the exposed cement. 

Before installing pool fencing, you must consider certain pool fencing compliance requirements. These are important to avoid accidental drowning in children. Following these requirements will also prevent you from paying expensive fines.

1. Height - each pool owner should follow specific height requirements for pool fences. In NSW, the minimum height for pool fencing is 1200mm.

2. Ground distance - ensure that the distance between the bottom of the pool fence and the ground does not exceed 100mm. 

3. Vertical and horizontal spacing - the vertical bar spacing should not be greater than 100mm. For horizontal bars, the clearance should be 900mm.

4. No-climb areas - make sure to maintain a no-climb area around the pool fence. This is to prevent your child from entering the pool with potential hand and foot grips.

There are many things that must be considered when installing pool fencing. As a pool owner, you have to pay great attention to detail. This is to avoid unnecessary accidents such as drowning. With this guide, you can now properly install pool fencing for your pool.

The above describes the installation steps of the swimming pool fence. If you want to buy a swimming pool fence, please contact us.

MAYGO POOL is a professional custom swimming pool accessories manufacturer, we focus on providing professional technical solutions for residential and commercial swimming pools. At present, we have provided swimming pool solutions to thousands of customers in North America, South America, Europe, Australia, etc.